Publicidad
Threading
the
left needle
r
Place the spool of thread on the left side spool pin,
Left needle threading points are marked in orange,
There is a convenient threading chart located on the
machine body behind the looper cover,
C) Thread guide
O Thread guide plate
(&) Left needle thread tension dial
(_ Thread take-up lever cover
Needle thread guide
(_ Needle bar thread guide
0 Left needle
[] Draw the thread through the thread guide on timeleft
from back to front.
Thread guide
If the thread slips out from the thread guide groove while
serging, pass the thread through the thread guide hole
as shown,,
[] Pass the thread through the holes on the left of the
thread guide plate as illustrated.
(_ Thread guide plate
[] Insert thread between the tension discs.
Hold the thread at both ends and tug gently to ensure
timethread is fully inserted between the tension
discs
(_ Left needle thread tension dial
Thread take-up lever cover
[] Turn the handwheel toward you to bring the needle bar
to its highest position, then pass the thread through the
thread take up lever cover (_,
[] Pass the thread through the needle thread guide sliding
the thread from right to left.,
[] Pass it through the needle bar thread guide from left to
right.
[] Thread the left needle from front to back and pull the
thread about 4 _ (10 cm) from the eye of the needle to the
back,
O Needle thread guide
_) Needle bar thread guide
O Left needle
To finish threading:
Gently pull all four thread ends towards the back of
the machine,
Run threads under the presser foot and lower the
presser foot,
Close side cover and looper cover,
-- Turn handwheel toward you to chain off three or four
stitches,
The sewing preparation is now complete,,
_
J
I
®
f
%@%
®
36
Publicidad
Capítulos
