Yamaha WaveRunner SUV SV1200 Manual De Servicio página 262

JET
PUMP
IMPELLER DUCT AND DRIVE SHAFT
Bearing inspection
1. Inspect:
Front and rear bearings
(rotate each inner race by hand)
Damage/rough movement →
Replace.
Drive shaft installation
1. Install:
Oil seal
Driver rod:
YB-06071/90890-06606
Ball bearing attachment:
YB-06156/90890-06634
2. Install:
Front bearing
Drive shaft
NOTE:
Install the front bearing and drive shaft with
a press.
Distance a:
23 ± 0.1 mm (0.91 ± 0.004 in)
3. Add:
EPNOC grease AP #0
(between the drive shaft and spacer)
Quantity:
Approximately 1/3 of capacity
4. Install:
Rear bearing
Bearing inner race attachment:
YB-34474/90890-06662
NOTE:
Hold the drive shaft and impeller duct and
press them with the bearing inner race
attachment.
6-12
E