Yamaha WaveRunner SUV SV1200 Manual De Servicio página 268

JET
PUMP
TRANSOM PLATE AND HOSES
a
SERVICE POINTS
Bilge strainer inspection
Refer to "JET PUMP UNIT" in
chapter 3.
Bilge hose inspection
1. Inspect:
Bilge hose
Cracks/damage/wear → Replace.
Transom plate installation
1. Install:
Transom plate
Shim
Installation steps:
Install the transom plate.
Measure the clearance a at each stud
bolt hold.
Install the suitable shim from the table
below.
Clearance a
0 ~ 0.5 mm
(0 ~ 0.020 in)
0.5 ~ 1.0 mm
(0.020 ~ 0.039 in)
1.0 ~ 1.5 mm
(0.039 ~ 0.059 in)
NOTE:
Install the shim(s) to the original position if
the bearing housing is not relpaced.
6-15
E
Shim thickness
No need
0.5 mm
1.0 mm