USE AND OPERATION
In "convection cooking" mode you can adjust
the percentage of opening of the vent , which is
shown on the display (13) ("0" = vent always open;
"_ ._" = vent always closed) .
– Increases the percentage of humidity: keep the
button pressed to introduce humidity inside the
oven during any mixed or convection cooking
phase.
– While cooking in "steam cooking" mode, this
switches from standard (Std) steam to super (Sup)
steam and vice-versa.
– To set the default value between Std and Sup
steam: With appliance in STOP phase (green indi-
cator light (2) on) press the button (14) longer than
3 seconds (the entire panel switches off ). Keep the
button (8) pressed and act on the knob (10) to se-
lect Std or SUP. Press the knob (10) to confirm the
change made.
9) Product core probe or "vacuum" temperature
setting button"
– Sets the cooking temperature inside the product:
measured by the core probe (optional) or with vac-
uum (optional); press once (green light flashes) to
set the temperature using the knob (10).
– Modifies the temperature inside the product dur-
ing cooking: press once to show the temperature
value on the display (12).
Press the button and turn the knob (10) to modify
the value set.
Wait about 5 seconds for the new value set to be
saved.
This function disables use of the "Time setting"
button (Timer) .
10) Control knob
– For varying the values of the functions selected (see buttons 6, 7, 8, 9).
Turn the knob clockwise to increase the value and anti-clockwise to decrease it.
– Used to modify the cooking and washing programming parameters and the appliance's functional
parameters.
– Also confirms and saves: press the knob to confirm and save the settings selected and/or shown on
the display.
11) Temperature display
– Shows the value of the temperature set.
To display the real temperature inside the oven, keep button (6) pressed until the display shows the
dot in the lower right.
The value on the display flashes at the start of a cooking process when the temperature inside the
oven is higher than the temperature set and/or during preheating when the set temperature has not
been reached.
– During a pause in cooking, it shows the number of the "Regeneration" program available for selection
using button (15).
12) Time and "product core probe" display
With button (7) (timer) pressed:
– In cooking pause status it shows the value of the time set.
– During cooking it shows the time left to the end of the cooking cycle.
With button (9) ("product core probe" temperature setting) pressed:
– In cooking pause status it shows the value of the temperature set.
– During cooking it shows the value of the temperature measured by the probe.
3326461_GB_rev.1
3 4 5
11
6
REAL
7
8
INJ
14
15
10
18
ENGLISH
2
12
9
13
17
16
15