Audi 8V0.055.204.A Instrucciones De Instalación página 121

Installation instructions - Audi A3 2013 ► Audi A3 2014 ► Electrics set for removable tow-
ing bracket, scope of delivery 8V0.055.204.A Audi Genuine Accessories
Edition 03/2014
◆ Battery has been disconnected
◆ Socket retrofit wiring harness has been fitted
◆ The lower left-hand section of the A-pillar trim has been re-
⇒ P age
moved 34.
◆ The left-hand sill panel trim has been removed
◆ Left-hand side trim has been removed
Installation
– Route the retrofit wiring harness -2- along the standard wir-
ing harness to the trailer detector control unit -J345- and
connect to the trailer detector control unit -J345- -1-.
– Make the earth connection -3-.
– Secure the retrofit wiring harness -2- to the standard wiring
harness using cable ties.
The wires must be secured with cable ties to stop them from
"slipping" or "wearing".
– Route the retrofit wiring harness -2- along the standard wir-
ing harness to the relay and fuse carrier behind the storage
compartment on the driver side (left-hand drive vehicles) or
the glove box (right-hand drive vehicles).
– Secure the retrofit wiring harness -2- to the standard wiring
harness using cable ties.
Notes on further installation
WARNING
DO NOT connect the battery!
The battery is reconnected ONCE ALL WORK HAS BEEN
COMPLETED.
Earth point tightening torque: 9 Nm
6.5 Removing the relay and fuse carrier
Preparatory work
◆ Battery has been disconnected
◆ Left-hand drive vehicles: The dash panel cover on the driver
side has been removed
◆ Right-hand drive vehicles: The glove compartment has been
⇒ P age
removed 31.
◆ Front left-hand knee airbag has been removed
52
6 Electrical connection
⇒ P age
13.
⇒ P age
⇒ P age
40.
⇒ P age
13.
⇒ P age
29.
46.
⇒ P age
32.
⇒ P age
42.