Audi 8V0.055.204.A Instrucciones De Instalación página 125

Installation instructions - Audi A3 2013 ► Audi A3 2014 ► Electrics set for removable tow-
ing bracket, scope of delivery 8V0.055.204.A Audi Genuine Accessories
Edition 03/2014
– Insert the fuse contacts from the 4-slot fuse adapter into the
contacts D122 and J126 on the fuse carrier.
1 - Contact D122: wire for fuses 1 and 2
2 - Contact J126: wire for fuses 3 and 4
– Push the protective caps on the wires onto the fuse carrier
until the protective caps audibly engage.
WARNING
DO NOT connect the battery!
The battery is reconnected ONCE ALL WORK HAS BEEN
COMPLETED.
6.7 Connecting the CAN bus/terminal 15/
brake light signal
The CAN bus/terminal 15/brake light signal is connected to the
on-board supply control unit -J519- behind the dash panel cover
on the driver side/behind the glove compartment. Connectors A
and C on the on-board supply control unit -J519-are used.
Preparatory work
◆ Battery has been disconnected
◆ On-board supply retrofit wiring harness has been fitted
⇒ P age
49.
Installing the wire for the CAN bus/terminal 15 (connector
A)
– Release and disconnect connector A -1- on the on-board
supply control unit -J519-.
56
6 Electrical connection
⇒ P age 13