Audi 8V0.055.204.A Instrucciones De Instalación página 126

Installation instructions - Audi A3 2013 ► Audi A3 2014 ► Electrics set for removable tow-
ing bracket, scope of delivery 8V0.055.204.A Audi Genuine Accessories
– Open the connector housing and unpin contacts 14, 16 and
17.
– Pin the corresponding contacts of the retrofit wiring harness
(Y-wire) into connector A.
◆ Pin 14: terminal 15, black
◆ Pin 16: CAN bus high, orange/green
◆ Pin 17: CAN bus low, orange/brown
– Pin contacts 14, 16 and 17 from connector A into the 3-pin
contact housing for the retrofit wiring harness.
1 - Terminal 15, black
2 - CAN bus high, orange/green
3 - CAN bus low, orange/brown
Installing the wire for the brake light signal (connector C)
– Release and disconnect connector C -2- on the on-board
supply control unit -J519-.
– Open the connector housing and unpin contact 58.
– Pin the corresponding contact of the retrofit wiring harness
(Y-wire) into connector C.
◆ Pin 58: brake light, black/red
– Pin contact 58 from connector C into the white 3-pin contact
housing of chamber 2 on the retrofit wiring harness.
Notes on further installation
– Close the connector housing back up and attach to the on-
board supply control unit -J519-.
WARNING
DO NOT connect the battery!
The battery is reconnected ONCE ALL WORK HAS BEEN
COMPLETED.
6.8 Reassembling the vehicle
To install the components, follow the removal steps in reverse
order. Observe the "Notes on installation" for the relevant com-
ponents and the corresponding tightening torques.
Edition 03/2014
6 Electrical connection
57