Publicidad
Idiomas disponibles
Idiomas disponibles
Connect the metal structure of the electrical appliance to the
equipotential node. Connect the conductor to the terminal with
the symbol
on the outside part of the bottom.
• This symbol indicates that the appliance must be included in
an equipotential system connected in compliance with cur-
rent regulations.
12 CONVERSION TO A DIFFERENT TYPE OF GAS
• which gas can be used for the appliance.
• the nozzles and settings for each gas that can be used.For
nozzles, the number indicated in table T1 is also stamped on
the nozzle body.
To convert the appliance to the local gas type, follow the in-
structions given in a table T1 and carry out the steps below:
• Replace the main burner nozzle ( UM ).
• Adjust the main burner's air regulator to distance A.
• Replace the pilot burner nozzle ( UP ).
•
• Replace the gas valve minimum nozzle ( Um ).
•
nozzles and adhesive tabs are supplied with the appliance.
REPLACING THE MAIN BURNER NOZZLE AND ADJU-
STING THE PRIMARY AIR FLOW.
• Slacken screw V.
•
with the one indicated in table T1.
•
• Adjust air regulator Z to distance A as shown in table T1.
• Retighten screw V fully.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
REPLACING THE PILOT BURNER NOZZLE
• Undo connector R.
• Remove nozzle UP and replace it with the one indicated in
table T1.
• Retighten connector R.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
13 COMMISSIONING
See Chapter " INSTRUCTIONS FOR MAINTENANCE".
INSTRUCTIONS FOR USE
REMINDERS FOR THE USER
The manufacturer will not be liable for
any damage or injury resulting from fai-
lure to observe the following rules.
• Read this manual carefully. It provides im-
portant information for safe installation,
use and maintenance of the appliance.
• Keep this manual in a safe place known to
all users so that it can be consulted throu-
ghout the working life of the appliance.
•
of gas and appliance maintenance must
thorized by the manufacturer, in complian-
ce with current safety standards and the
instructions given in this manual.
• For after-sales service, contact technical
assistance centers authorized by the ma-
nufacturer and demand the use of original
spare parts.
• Have the appliance serviced at least twice
a year. The manufacturer recommends ta-
king out a service contract.
• The appliance is designed for professional
use and must be operated by trained per-
sonnel.
• The appliance is to be used for cooking
use. Any other use is considered to be im-
proper.
• Do not allow the appliance to operate emp-
ty for prolonged periods. Only pre-heat the
oven just before use.
• Do not leave the appliance unattended
while in operation.
• In the event of an appliance fault or mal-
installed upline.
• Clean the appliance following the instruc-
tions given in Chapter " INSTRUCTIONS
FOR CLEANING".
•
proximity to the appliance. FIRE HAZARD.
• Do not obstruct any air vents or drains pre-
sent on the appliance.
• Do not tamper with appliance components.
•
the appliance.
• The use of personal safety equipment is
recommended - risk of very hot food being
scattered.
•
rounding the appliance may become slip-
pery: exercise caution and take all suitable
measures to prevent falls.
-
-
7
Publicidad
