Publicidad
Idiomas disponibles
Idiomas disponibles
•
pliance.
ELECTRONIC ELECTRIC FRYERS
The appliance does not heat.
Possible causes:
• Temperature thermostat defective.
• Heating elements defective.
• Safety thermostat tripped.
Heating cannot be adjusted
Possible causes:
• Temperature thermostat defective.
16 REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS.
• Disconnect the appliance electrical power supply, if present,
before proceeding with any operation.
• After replacing a gas system component, check for gas leaks
at connection points.
• After replacing an electrical system component, check it is
correctly wired.
GAS FRYERS
Replacing the gas valve and safety thermostat.
•
• Open the door.
• Remove the control panel.
• Unscrew the locking nut in the well.
• Remove and replace the component.
• Change the sensor/bulb sealing O-ring in the well.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the burner, the pilot burner, the thermocouple,
the piezoelectric ignition and the igniter.
• Open the door.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
ELECTRIC FRYERS
•
• Open the door.
• Remove the control panel.
•
• Release the thermostat bulb to be replaced; it is secured
• Disconnect the electrical connections to other devices.
• Remove and replace the component.
• Change the sensor/bulb sealing O-ring in the well.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the heating element
•
• Remove the control panel.
• Release the thermostat bulbs secured between the heating
elements.
• Disconnect the electrical connections to other devices.
-
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
ELECTRONIC GAS FRYERS
Replacing the main burner, pilot burner, thermocouple and
igniter.
• Open the door.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the temperature control digital thermostat
• Remove the control panel.
• Disconnect the temperature sensor.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the temperature sensor and safety thermostat.
•
• Open the door.
• Remove the control panel.
• Unscrew the locking nut in the well.
• Remove and replace the component.
• Change the sensor/bulb sealing O-ring in the well.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the main switch, electronic igniter, fan, fuses.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
ELECTRONIC ELECTRIC FRYERS
Replacing the heating element
•
• Remove the control panel.
• Disconnect the electrical connections to other devices.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the temperature sensor and safety thermostat.
•
• Open the door.
• Remove the control panel.
•
• Disconnect the electrical connections to other devices.
• Remove and replace the component.
• Change the sensor/bulb sealing O-ring in the well.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
17 CLEANING THE INTERIOR
• Check the condition of the inside of the appliance.
• Remove any built-up dirt.
• Check and clean the fumes exhaust system.
18 MAIN COMPONENTS
GAS FRYERS
• Gas valve
• Main burner
13
Publicidad
