Handling And Transportation; Warranty Coverage; Assistance And Repairs - Stiga SP 386 Manual De Instrucciones

8. Pour a teaspoon of (new) 2-stroke
engine oil into the spark plug slot.
9. Pull the starter handgrip several
times to deliver oil to the cylinder.
10. Replace the spark plug with the
piston in the dead end upper position
(visible from the spark plug slot when
the piston is at maximum stroke).
11. Clean the machine thoroughly.
12. Check the machine for any
damage. If necessary, contact the
authorised assistance centre.
13. Store the machine:
– in a dry place
– protected from inclement weather
– with the bar cover guard fitted correctly
– in a place where children cannot get to it
– making sure that keys or tools used
for maintenance are removed.
Before starting to use the machine again:
1. Remove the spark plug.
2. Pull the starter handgrip a few
times to eliminate excess oil.
3. Check the spark plug (par. 8.5).
4. Arrange the machine (par. 4.2 chap. 6)

10. HANDLING AND TRANSPORTATION

When handling or transporting
the machine, always:
– Stop the machine (par. 6.6).
– Wait until the chain is stationary.
– Remove the spark plug cap (Fig. 30.A).
– Mount the bar cover.
– Only hold the machine using the handgrips
and position the bar in the opposite
direction to that used during operation.
When transporting the machine
on a vehicle, always:
– position it so that it can not cause
a hazard for anybody
– fasten firmly to the means of transport using
ropes or chains to prevent it from tipping
over causing damage and fuel leaks.

11. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorized Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorized
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only authorized service workshops can carry
out guaranteed repairs and maintenance.
• The authorized service workshops
only use genuine spare parts. Genuine
spare parts and attachments have been
designed specifically for machines.
• Non-genuine spare parts and attachments are
not approved. Use of non-genuine spare parts
and attachments cause the warranty to expire.
• It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance
and safety device inspection.

12. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover
damages caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of attachments not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as cutting means, safety bolts.
• Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
EN - 17