Electrical Diagram Of Hydraulic Power Pack With Electric Motor; Assembly Diagrams; Setting Into Service; Supertirfor™ Machine - Tractel supertirfor Serie Traducción Del Manual Original

2.1.7 Electrical diagram of hydraulic power pack with electric motor

GB
3 kW motor
230 V - 11.9 A
400 V - 6.86 A
Cable gland: 20X1.5

3. Assembly diagrams

The supertirfor™ machine is rigged on a fixed anchoring point, with the
supertirfor™ wire rope moving through the unit (page A, figures 4, 5 and 6).
DANGER: Any installation requiring calculation of the forces applied
and verification of the strength of the fixed anchoring point used must be
inspected by a qualified technician familiar with this type of equipment.
DANGER: When performing work such as guiding a falling tree, the
operator must stand clear of the danger area, running the supertirfor™
wire rope through one or several pulleys.
NOTE: Whatever the assembly diagram, if the supertirfor™
machine is secured directly to a fixed anchoring point, it should be able
to line up with no interference with respect to the direction of the load
or effort. For this purpose, a sufficiently strong sling should be installed
between the anchoring point and the machine (page A, figure 7).
NOTE: Whatever the assembly diagram used, be sure to always
leave the oil supply and return hoses free to move, avoiding, in particular,
any abrupt, constraining angles.
The capacity of the supertirfor™ machine can be increased using pulley
blocks (see diagram examples on page A, figures 10 and 11).
The increase in capacity indicated is reduced in accordance with the
efficiency of the pulleys.
The diameter of the wheel groove on the pulleys used must be at least
16 times the diameter of the supertirfor™ wire rope (see applicable
regulations if necessary).
10
3 kW motor

4. Setting into service

4.1 Supertirfor™ machine

4.1.1 TU16H

1. Install the ram bracket (item 29, figure 14, page B) on the attachment
fitting (item 27) of the unit. A 13 mm tubular socket wrench is required
for this operation. Proceed as follows:
• R emove the 6 screws and washers (item 1) and the bolt and washer
(item 2).
• S lightly loosen the 4 screws (item 3) on one side of the unit.
• I nstall the ram bracket (item 29), positioning it on the locating pins
(figure 15, item 1, page B).
• I nstall the 6 screws and washers (item 1) then install the bolt and
washer (item 2).
• L ock all the screws (items 1, 2 and 3).
DANGER: Never use the supertirfor™ machine if there is any foreign
matter inside the unit.
IMPORTANT: When removing and installing the screws (item 1),
be careful not to allow any washer to fall into the housing of the TU16H.
If a washer falls into the unit, you must absolutely, mandatory recover it.
2. Identify the desired working direction. Secure the VA2 ram on the
ram bracket (page B, figure 16, item 29), using the pin, in the position
corresponding to the working direction:
- FORWARD OPERATION: ram in position A.
- REVERSE OPERATION: ram in position C.
3. Secure the ram yoke (page B, figure 16, item 31) on the forward or
reverse operating lever using the pin.
- FORWARD OPERATION: ram yoke in position B.
- REVERSE OPERATION: ram yoke in position D.