Publicidad
EN
PROBLEMS
The spray pump (A)
does not work under
pressure.
The spray pump (A)
does not reach the
pressure on the PLATE.
Cardan shaft broken,
sli-
ding
profiles/protective
pipes are damaged.
Sliding profiles
deformed very dirty.
Chain broken or
support damaged.
CAUSES
• Air intake
• Intake filter ring (B) loose.
• OR intake filter not positioned in its
seat and/or expanded.
• Intake filter cartridge (C) clogged.
• Intake hose clogged
• Yellow cap (D) not mounted
correctly.
• Insufficient number of revolutions of
the pdf
• Insufficient number of revolutions.
• Worn nozzles
• Extractor filter (C) partially clogged.
• Cardan shaft too short.
• Incorrect coupling due to expansion
of the cardan shaft.
• Chain attached incorrectly or too
short.
D
B
Pulverizadores
suspendidos
SOLUTIONS
• Check the suction apparatus.
• Check tightness.
• Set the OR in the seat or replace it.
• Wash the filter cartridge.
• Remove the intake hose and clean it
• Remove the yellow cap and remount
correctly.
• Increase the number of revolutions
(max
540 rpm)
• Reset the number of revolutions PDF
(MAX 540 rpms).
• Replace nozzles
• Clean filter cartridges
• Use a more appropriate cardan.
• Connect properly.
• Reset the
parts.
C
93
Mounted sprayers
Publicidad
