KIKKA BOO BELOVED Instrucciones De Uso página 7

IMPORTANT! KEEP FOR FUTURE REFERENCE!
EN
READ CAREFULLY!
The instructions for use must be kept for the entire life of the universal belted enhanced child restraint system.
WARNING!
1.This car seat provides optimal safety in all installation positions for which it was designed.
2. This is an i-Size Universal Belted Enhanced Child Restraint System (40-87cm). It is approved pursuant to European Regulation 129 ( ECE R129 ), for use in i-Size compatible car
seats as indicated by manufacturers in the car owner's manual. If you have questions, please consult either the Universal Belted Enhanced Child Restraint System manufacturer or the
distributor.
3. This is an 'i-Size Universal Belted Enhanced' child restraint system, approved pursuant to European ECE R129, for its general use in cars, although it is not suitable for all cars.
4. It should be installed in cars for which the manufacturer states in its car owner's manual that the vehicle is suitable for an 'i-Size Universal Belted Enhanced' child restraint system for
this age range.
5. The product has been approved pursuant to European regulation ECE R129 and can be used for heights between 40 and 87 cm and maximum weight of 15 kg.
6. Make sure that the buckle is correctly fastened before starting to drive.
7. Any straps holding the restraint to the vehicle should be tight, that any support-leg should be in contact with the vehicle floor, that any straps or impact shields restraining the child
should be adjusted to the child's body, and that straps should not be twisted.
8. Ensure that any strap or belt that holds the child is not folded or twisted and remains tightened.
9. Ensure that the abdominal belt or strap rests as low as possible over the child's hips, on both sides.
10. In the event of an accident, even if there are no apparent damages, the seat may be unsafe. The seat should be replaced after being subjected to the sudden and strong stresses
associated with an accident.
11. Instructions illustrations are for informational purposes only. The child universal belted enhanced restraint system may contain small differences compared to the photographs or
images in the instructions manual. These variations do not affect its approval by Regulation ECE R129.
12. Under no circumstances should the car seat be installed in the car's passenger seat opposite the direction of travel if there is an active airbag.
13. Please read the instructions carefully, as incorrect installation could result in serious injury. In this case, the manufacturer shall not be held liable.
14. Ensure that all the locking devices are engaged before use.
15. It is dangerous to undertake any changes or additions to the safety seat with approval from the competent authority. It is dangerous to not strictly follow the installation instruc-
tions provided by the child car set manufacturer.
16. Please never use the safety seat without its cover or without the harness protectors.
17. Make sure to protect the child safety seat from direct sunlight as it could heat up and hurt the child.
18. The car seat should remain permanently installed in the vehicle, even when the child is not in it. Never leave the child unattended when sitting in the car seat, even when the seat
is outside the vehicle.
19. Make sure that any luggage or objects that could cause injuries in the event of an accident are fastened securely.
20. The cover of the universal belted enhanced restraint system should not be replaced with another, unless recommended by the manufacturer, because it is an integral part of the
system for securing children!
21. It should be installed in cars for which the manufacturer states in its car owner's manual that the vehicle is suitable for an 'i-Size Universal Belted Enhanced' child restraint system
for this age range.
22. Security is only guaranteed if the child restraint is fitted in accordance with these instructions.
23. For the i-Size universal belted enhanced child restraint system, the user must read the instructions manual of the vehicle's manufacturer.
24. Don't use in forward facing positions.
25. Do no use rearward facing child seat in seating positions where an active frontal airbag installed. Death or serious injury can occur.
26. It is important to ensure that any lap strap is worn low down, so that the pelvis is firmly engaged.
27. The instruction must be retained on the child restraint for its life period.
28. The hard components or plastic parts of safety device for children should be deployed and installed in way that during everyday use of the vehicle not be jammed by the movable
seats or doors. Prevent harness/vehicle belt from getting trapped between car doors or rubbing against sharp parts of the seat or body.
29. All belts that fix the restraint system to the vehicle must be tightened , all belts retaining the child must be adjusted according to the child's body. Twisting of the belts shall not be
allowed.
30. Don't use another support point of contact except the ones described in the instructions and marked on the universal belted enhanced child restraint system.
31. If the universal enhanced belted child restraint system offers alternative support point of contact and you consider that using that alternative route is not satisfactory, please
contact the manufacturer of the universal belted child restraint system.
32. Install the car seat in the seating positions indicated in this instruction.
33. Do not use the car seat in the house. It is not designed for home use and should only be used in the vehicle.
34. Before you set any mobile or adjustable part of the child seat, you need to remove your child from the child seat.
35. Check regularly the belts for wearing by paying special attention to the fixing points, the safety guards and the adjusting devices.
36. Do not leave the buckle partially closed, it must be locked when all parts are engaged. You must be able to remove the child from the seat immediately in case of emergency. You
have to teach the child not to play with the buckle.
37. Keep the child's chair at a safe place away from children when not in use. Avoid placing heavy objects on the chair. Prevent contact of your vehicle chair with corrosive substances,
for example acid from the battery.
1
NOTICE
Do NOT install in front seats except in these specific cases:
1. When the car does not have back seats.
2. When all back seats are occupied by children less than or equal to 135 cm tall.
3. When it is not possible to install all child restraints in the back seats.
In seats with approved three-point retractor seat belts.
2
ATTENTION
The child seat must only be used in this seat with approved three-point retractor seat
1
belts: diagonal (A) and abdominal (B).
ENGLISH
IMPORTANT! KEEP FOR FUTURE REFERENCE!
EN
READ CAREFULLY!
I. CAR SEAT PARTS
1. Handle; 2. Headrest; 3. Shoulder straps; 4. Buckle; 5. Crotch pad; 6. Harness strap; 7. Canopy frame joint parts; 8. Chest pad; 9. Lap belt guide; 10. Crotch strap; 11. Inner cushion
(Child height: 40-60cm); 12. Handle rotation button; 13. Seat body; 14. Diagonal belt guide; 15. Headrest height adjuster; 16. Harness strap connector.
II. USE IN THE VEHICLE
1. HEIGHT ADJUSTMENT FOR SHOULDER STRAPS AND HEADREST
• According to children's different height, headrest height and the shoulder strap height can be adjusted up and down, totally 7 positions.
• Press the harness adjuster, while pulling out the shoulder towards you to the proper length to loosen them.
• Squeeze the headrest height adjuster, adjust the headrest up and down according to your child's height.
• Release the headrest height adjuster, the headrest and the shoulder belts reach the desired height and you will hear a "click".
• The harness strap should be leveled with your child's shoulders. Check that the headrest is properly engaged by sliding the headrest down a little.
2. LOOSEN THE SHOULDER STRAPS
Step 1: The shoulder straps are slackened by pressing the harness adjuster under the sign of "Press" on the front of the infant carrier.
Step 2: Press down on the sign marked "Press" as you grip the two shoulder straps with your other hand. Pull the shoulder straps towards you to loosen them.
3. TIGHTEN THE SHOULDER HARNESS
• Pull the shoulder straps upwards to remove the whole harness by pulling the harness adjuster strap until it is fully tightened.
• The harness should be adjusted as tightly as possible without causing discomfort to your child.
• To release the harness, press the red button on the buckle downwards.
4. USAGE OF INNER CUSHION
• The inner cushion must be used for the child height of 40-60cm.
• Place the inner cushion in the infant carrier and guide the shoulder straps through the two sides of the upper parts of the inner cushion, then lay both shoulder straps over the lower
part of the inner cushion .
• Guide the harness buckle and the crotch pad through the openings in the bottom part of the inner cushion.
• Always make sure that your child is properly secured.
• To take off the inner cushion, repeat the above prescribed procedures in reverse order.
5. SECURE THE BABY WITH THE HARNESS
• Loosen the harness, adjust the shoulder straps height and headrest height. Place the inner cushion in the infant carrier.
• Press the red button on the buckles downwards and open the buckle, and place them down sideways. Put your child in the infant carrier. Place both shoulder straps over your child's
shoulders.
• Put the buckle tongue 1 and 2 together, slot the two buckle tongues into the slot in the top of buckle until they "click" into place .
• Check if the harness is correctly locked by pulling the shoulder straps upwards.
• To release your child, repeat the above prescribed procedures in reverse order.
6. ROTATE THE HANDLE
• Please press the handle rotation buttons on both sides at the same time. Now it can be rotated.
• The handle has four positions:
1) Rearward facing installation in the car. This position (only this position) is suitable for the infant carrier installed on the vehicle seat.
2) Straight up for carrying.
3) Handle clicked back to initiate the rocking feature.
4) Down to support baby for feeding and play.
Ensure that the handle is locked in a position, the harness is correctly fitted and buckle fastened before carrying your car seat.
7. CANOPY ASSEMBLY
1) Rotate the handle to the position same as on the picture.
2) Insert the frame through the sleeve of the canopy.
3) Insert both ends of the canopy frame into the canopy frame joint parts which is located on the both side of the infant carrier and above the handle.
4) Fix the bottom of the canopy cover to the top of the infant carrier back.
5) Rotate the canopy frame joint parts and the canopy will reach the proper position you want.
6) Rotate the handle until it reaches the proper position you want.
When you do not need canopy just take it off in reverse order of the above instruction.
III. SECURE THE INFANT CARRIER WITH THE 3-POINT SEAT BELT
Step 1: Place your child in the infant carrier. Rotate the handle to the upright position. Place the infant carrier on the vehicle's seat ensuring it is firmly pressed against the car seat
backrest.
Step 2: Slide the lap belt of the vehicle's 3-point seat belt through both lap belt guides. Let the tongue plate snap in the belt lock with a clearly audible "click". Pull the shoulder belt in
arrow direction to tighten the lap belt. Check to make sure the tongue plate is locked by pulling on the belt.
Step 3: Guide the diagonal belt in the diagonal belt guide at the back of the infant carrier.
Step 4: Tighten the vehicle's 3-point seat belt by pulling hard on the positions.
Step 5: Rotate the handle to the forward position.Ensureit is firmly against the vehicle seat backrest.
2
Make sure all the belt positions are right and they are not twisted.
IV. MAINTENANCE AND CLEANING
In daily use, check periodically the enhanced child seat. The infant carrier should be replaced after an accident. Please keep this infant carrier in dry and ventilated place to avoid damp
moldy. If the infant carrier becomes dusty, clean the seat belt and the plastic pieces by swiping them with a damp sponge and let it dry under ambiance. Never use any solvant,
chemical detergent or lubricant on any part of your infant carrier.
ENGLISH