POWR
ASSEMBLY AND ADJUSTMENT/INSTALLATION
G76002-0*
INTAKE MANIFOLD
1) Install the reed-valve assembly, and the gasket
reed-valve plate to the intake manifold.
2) Install the manifold assembly to the crankcase.
G77000-0*
FUEL SYSTEM AND ELECTRICAL SYSTEM
1) Install the fuel system referring to page 4-1.
2) Install the electrical system referring to page 3-
2.
G80002-0*
INSTALLATION
1) Install locating pins in position on the exhaust
guide.
2) Align the locating-pin holes on the gasket with
dowel pins, and place the gasket on the bottom
cowling.
3) Install the power head onto the bottom cowling,
tighten the mounting-bolts to the specified
torque.
Mounting Bolts:
21 Nm (2.1 m·kg, 15 ft·lb)
4) Connect to the hoses, cables and wires refer-
ring to page 3-2, 3-3.
5) Check the fittings installation, cable connec-
tions and functions before starting the engine to
check operation and to check for leaks, refer-
ring to page 3-3.
5-26
E