Yamaha 20C Manual De Servicio página 174

POWR
RECOIL STARTER
Starter spring
1) Visually inspect the starting spring and replace
it if it is broken or has distorted ends.
Start-in-gear protection
1) Inspect the starter stop-plunger and replace it if
is cracked or damaged.
2) Inspect the cable and replace it if it shows signs
of fraying or sticking.
H13008-0*
ASSEMBLY
1) Hook the outer end of the starter-spring onto
the retainer-post attached to the starter-case,
and install the spring onto the starter case by
winding it counterclockwise.
NOTE:
1. Apply Yamaha marine grease to the inner surface
of the starter case.
2. Each new starter-spring is bound by a steel
hoop. To install, hook its outer end onto the
retainer-post first, put it into the starter case, and
then remove steel hoop.
2) Insert the rope through the rope-holes, and
knot the ends.
3) Wind the rope 2-1/2 turns on to the sheave
drum.
4) Place the rope at the cutaway.
5-30
E