Yamaha 20C Manual De Servicio página 220

LOWR
INSTALLATION
6) Install the spacers, propeller, washer and pro-
peller nut over the propeller shaft.
Propeller nut:
30 Nm (3.0 m·kg, 22 ft·lb)
7) Align the recess in the propeller nut with the
hole in the propeller shaft and insert the cotter
pin into the hole. Be sure bend the cotter pin
ends.
8) Fill with fresh gear oil through the oil plug hole
until oil flows out through the level plug hole,
then secure the plugs in these two holes. (The
check plug first)
6-20
E