Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3 INSTALLATION
1
ALL STAGES OF INSTALLATION MUST BE CAR-
RIED OUT IN COMPLIANCE WITH THE NATIONAL
STANDARDS IN FORCE ACCORDING TO THE MANU-
FACTURER'S INSTRUCTIONS AND BY PROFESSION-
ALLY QUALIFIED PERSONNEL
Installation of the appliance and of the refrigerating unit must
only be carried out by technicians of the manufacturer or
by skilled personnel.
If the machine was supplied with a remote condensing unit,
it is the installer's responsibility to check all the connections
in accordance with the instructions provided for the instal-
lation of systems and machinery.
The installer is advised to use the appropriate personal
protective equipment necessary for processing and in
compliance with the regulations in force.
3.1 Transportation and handling
The net and gross weight of this appliance can be found on
the external packaging.
Loading and unloading of the appliance and/or of the sub-
systems from the means of transport can be performed
using a forklift truck or fork pallet truck, the length of which
is more than half that of the unit or using cranes where the
appliance/subsystem is fitted with eyebolts. The lifting equip-
ment must be chosen according to the size of the packaged
machine/components and with sufficient capacity.
For handling of the appliance/subsystems, every precaution
must be taken not to damage them, respecting the indica-
tions on the packaging.
3.2 Unpacking and disposal
Remove all cardboard or the wooden crate from the base
on which the machine is placed. Then lift the machine/sub-
assemblies with a suitable means (forklift truck); remove the
wooden base and position the machine/sub-assemblies in
the place provided.
After removing the packaging, verify the integrity of the
machine/sub-assemblies In case of uncertainty do not use
it and contact the distributor.
Remove the protective PVC film on the stainless steel pan-
els from all sides both internally and externally.
8
Note: all the various components of the packaging must
be disposed of according to the regulations in force in the
country where the appliance is being used� In any case
nothing must be disposed of into the environment�
3.3 Positioning
The appliance:
•
must be installed in places where it can be checked
by qualified personnel.
•
it must not be installed outdoors.
•
it must not be installed in dusty environments.
•
it must not be placed in locations with the presence of
water jets.
•
it must not be washed with water jets.
•
It must be installed and tested in full compliance
with safety laws, traditional systems and with the regu-
lations in force.
•
it must be positioned at a minimum distance of 120 mm
from the rear wall
The installer must verify any requirements for fire safety
(refer to the command of the local fire department for the
relevant indications).
Level the appliance through adjustment of the feet. For the
setting up of heavier machines, use dedicated hoists (fig.
A - Chap. 3.1).
If the appliances are not levelled their functioning and the
flow of condensates could be impaired.
i
fig. A
71503136-0-R000
Publicidad
Capítulos
Tabla de contenido
