Removable Femur Jack Mount Assembly - Mizuhosi hana 6875 Manual Del Propietário

to unlock the spar. Release the safety latch by lifting it to allow the spar to be removed.
Slide the spar out of the spar mount.

8.2 Removable Femur Jack Mount Assembly

WARNING:
To ensure safe operation of the equipment, READ THESE INSTRUCTIONS
COMPLETELY and keep this instruction sheet readily available to operating room
personnel for future reference. Carefully observe and comply with all warnings,
cautions and instructions placed on the equipment or described in this manual.
Before use, inspect the device for possible damage, excessive wear or non-functioning parts.
Visually inspect all accessible areas, electrical cords and all movable parts for possible
®
damage that may adversely affect the proper operation of the hana Surgical Table.
Damaged or defective products should not be used or processed. Contact your local Mizuho
OSI sales representative for repair or replacement.
The 6875-730, removable jack mount assembly is designed to allow for removal and
reinstallation as needed depending on the type of surgical procedures being performed.
Removing the removable jack mount allows for C-arm access during hip arthroscopy and
certain fracture procedures. If C-arm access and certain fracture procedures are not
required, the removable jack mount may remain on the table.
®
The removable jack mount is located directly underneath the foot end of the hana Surgical
Table top between the removable leg spars (figure 20).
Figure 15: Spars are not shown for clarification purposes
MIZUHOSI 2009 24 NW0508 Rev. D