Im Nailing Tibia: Supine With Unilateral Skin Traction 6875 Hana - Mizuhosi hana 6875 Manual Del Propietário

8.12 IM Nailing Tibia: Supine With Unilateral Skin Traction 6875 hana

Table Set-Up
Figure 34: Patient positioned for Right IM Nailing Tibia in supine position with unilateral skin traction
Instructions provided are for suggested set-ups. Final determination of patient positioning
and set-up is at the discretion of the surgeon and surgical team.
1. Ensure all (4) caster floor locks are in the locked position.
2. If not already attached install the removable jack mount assembly (6875-730) refer to
section 8.2. Insert the appropriate femur lift (6875-600) right or (6875-601) left to the
operative side of the table. Refer to section 8.3.
3. Attach appropriate radiolucent leg spar (6875-360) right or (6875-350) left to the table
and lock in place. Refer to section 8.1.
4. Attach the lateral perineal post and pad assembly (6875-250) to table top by sliding
into position and inserting the plug into the standard perineal post opening on the
table top after removing the ilium post and lateral perineal post assembly. Attach well
leg support adaptor (6875-200) refer to section 8.5 into the leg spar mount on the non-
operative side of the table and lock into position.
5. Slide patient safety strap (5840-44) in place.
6. Attach optional patient transfer board (6875-742) by clamping the device to the leg
spar on the side of the table from which the patient will be transferred to the table.
Refer to section 8.6.
7. Adjust table height to appropriate position to transfer patient from patient stretcher.
8. Transfer patient to the table in a supine position and secure with patient safety strap
(5840-44).
9. Attach lateral perineal post (6850-400) to the traction lifter with the mounting bracket
lateral perineal post (6850-180) and position patient's leg over the lateral perineal
post.
10. Attach well leg holder (5855-838) to the well leg support adaptor (6875-200) using the
articulating bracket (6300-92) and secure patient's leg.
11. Install arm boards with pad (6875-292) to each side of the table and position patient's
arms out to the side, or attach arm boards with pad (6875-292) to the non operative
side of the table and optional cross arm support (5857) using clark socket (5393) to
the non-operative side of the table and secure the patient's arms.
12. Remove patient transfer board (6875-742) by unclamping it from the leg spar and
sliding it out from underneath the fully positioned patient.
13. Trial position the C-arm unit.
MIZUHOSI 2009 47
®
Surgery
NW0508 Rev. D