Total Knee Replacement 6875 Hana ® Surgery Table Set Up - Mizuhosi hana 6875 Manual Del Propietário

8.16 Total Knee Replacement 6875 hana
Instructions provided are for suggested set-ups. Final determination of patient positioning
and set-up is at the discretion of the surgeon and surgical team.
NOTE: The Knee Flexion System™ (6875-230) needs to be sterilized before use in surgery,
(reference section 8.7).
1. Ensure all four (4) caster floor locks are in the locked position.
2. If not already in place attach the radiolucent leg spar (6875-350 or 6875-360) to the
operative side of the table and lock in place. Refer to section 8.1.
3. Attach the well leg support adaptor (6875-200) to the non-operative side of the table and
lock in place.
4. Attach the articulating bracket (6300-92) to the well leg support adaptor (6875-200) and
tighten securely.
5. Insert the well leg holder (5855-838) into the articulating bracket (6300-92) and tighten
securely.
6. Install the lateral perineal post and pad assembly (6875-250) and perineal post and pad
(6850-413) for extra support if desired or use the standard pad and perineal post and pad
(6850-413).
7. Adjust table height to appropriate position to transfer patient form patient stretcher.
8. Transfer patient to the table in supine position and place well leg in well leg holder (5855-
838). Then secure patient with patient safety strap (5840-44).
9. Insert perineal post and pad (6850-413).
10. Pivot the arm board bracket into the appropriate position, insert arm support (6850-510)
and secure patients arms.
11. Drape operative side radiolucent leg spar (6875-350) and attach Knee Flexion System™
(6875-230). Refer to section 8.7.
12. Place operative side foot into Knee Flexion System™ (6875-230) and secure according to
surgeon protocol.
MIZUHOSI 2009
®
Figure 39: Patient positioned for total knee replacement
Surgery Table Set Up
55 NW0508 Rev. D