Attaching Femur Lift(S) And Femur Lift Foot Pedal 6875-600, 6875-601, 6875-19 - Mizuhosi hana 6875 Manual Del Propietário

8.3 Attaching Femur Lift(s) And Femur Lift Foot Pedal 6875-600, 6875-601, 6875-19

A single foot pedal is used to operate both left and right femur lifts. Switching operation from
one to the other is accomplished by rotating the femur lift control on the control panel in the
desired direction (see figure 4).
Attach the right or left femur lift to the corresponding mounting bracket by sliding into the
bracket and secure by turning the locking knob clockwise until hand tight.
Locking
knob
Attach the power cord connector extending from the mounting bracket to the port on the
bottom of the femur lift. Align the red dot on the power cord connector with the red dot on the
receptacle, and it will snap in place when properly aligned.
To remove power connector, pull down on the metal checkered jacket of connector.
Failure to properly disconnect connector can damage device.
MIZUHOSI 2009
Power cord
connector
Figure 21: Removing the power cord connector
WARNING:
28
Pull down and
then pull
connector out
of socket
NW0508 Rev. D