Optional Patient Transfer Assembly Instructions For Use - Mizuhosi hana 6875 Manual Del Propietário

8.6 Optional Patient Transfer Assembly Instructions For Use

Figure 26: Patient transfer assembly
The optional 6875-742, patient transfer assembly is intended for use while placing a patient
®
on a hana Surgery Table. The torso of the patient should be placed on the main table top of
®
the hana Surgery Table and the leg is to rest on the 6875-742, patient transfer assembly
before the foot is put into the boot.
WARNING:
The transfer board is designed only to safely support 60 lb. Placing the entire weight
of the patient on the transfer board will cause a failure of this product and could result
in injury to the patient or healthcare worker.
Setup:
The patient transfer accessory will clamp on either (left or right) spar. Clamp the device to the
side of the table from which the patient will be transferred to the table. Using the long handle
on the double bar clamp adjust the transfer board to best support only the leg or legs of the
patient. Secure the board in the desired orientation by tightening the handle (clock wise
rotation).
Use:
Transfer the patient to the table and rest the torso of the patient on the table top in a stable
position prior to lowering the leg or legs onto the transfer board. Lower the patient's leg to
the transfer board and place the foot or feet into the boots. After properly adjusting the
boots place the hook on the boot in the holder on the traction device in accordance with this
owners manual.
Remove the transfer board from the table when not using it to transfer a patient.
Clean exterior surfaces with a mild detergent solution and wipe dry with a soft lint-free cloth.
MIZUHOSI 2009 33 NW0508 Rev. D