General Description - Mizuhosi hana 6875 Manual Del Propietário

1.2 General Description

The Mizuho OSI 6875 hana
patient undergoing orthopedic surgical procedures including supine position for the anterior
approach for Total Hip Arthroplasty, Total Knee Arthroplasty, IM Nailing of the Femur or Tibia
and Hip Pinning, and Lateral position for IM Nailing of the Femur.
It is a stand-alone, single-pedestal, AC powered or internal battery powered table designed
to position a patient in a supine or lateral position during surgical procedures.
The table has a 2" (5 cm) MIZUHO OSI Tempur-Pedic
manufacture of MIZUHO OSI pads has viscoelastic properties and is a temperature sensitive
material, becoming softer where the patient's body is making the most contact with the
surface and remaining firm in areas where less body contact is being made. Pressure is
distributed evenly over the entire surface area. The pad is radiolucent, MR safe and latex
free. The benefits of using MIZUHO OSI Tempur-Pedic
management, reduced shear forces and enhanced patient comfort.
®
The hana Surgery Table has three primary electrically powered functions: height up/down,
left/right lateral roll and trendelenburg/reverse trendelenburg. Electromechanical actuator
motors perform these motions which are controlled by means of a hand pendant or onboard
auxiliary control panel with functions clearly labeled.
powered left and right femur lifts that are controlled by a foot pedal providing the surgeon the
ability to raise and lower the femoral hook during the anterior approach total hip arthroplasty.
Four (4) independent, manual caster floor locks are utilized to stabilize the table in the
operating location.
HEAD END
Manual caster floor
locks
Figure 1: Mizuho OSI 6875 hana
MIZUHOSI 2009
®
Surgery Table is designed to safely hold in proper position a
Manual caster floor
locks
®
6
®
pad. The TEMPUR
®
are improved pressure
The table is also equipped with
Surgery Table, right-side view
®
used in the
FOOT END
NW0508 Rev. D