Pneumatics - Festo 8108002 Instrucciones De Utilizacion

• Use only connecting cables with safety plugs for electrical connections.
•
Establishing and interrupting electrical connections
–
–
•
Always pull on the plug when disconnecting connector cables – never pull the
cable.
•
When laying connecting cables, make sure they are not kinked or pinched.
•
Do not lay connector cables over hot surfaces.
–
•
Make sure that connecting cables are not subjected to continuous tensile loads.
•
Use safety extra-low voltage (SELV) only: max. 24 V DC.
•
The device is not equipped with an integrated fuse unless specified otherwise in
the technical data.

5.5 Pneumatics

•
Depressurize the system!
–
–
–
• Risk of injury when switching compressed air on!
Cylinders may advance and retract automatically.
• Risk of accident due to advancing cylinders!
–
–
© Festo Didactic 8109530
Electrical connections may only be established in the absence of voltage.
Electrical connections may only be interrupted in the absence of voltage.
Hot surfaces are identified with a corresponding warning symbol.
Switch off the compressed air supply before working on the circuit.
Check the system with pressure gauges to make sure that the entire circuit is
pressure-free.
Please note that energy may be stored in pressure reservoirs.
Further information on this issue is available in the datasheets and operating
instructions included with the components.
Always position pneumatic cylinders so that the piston rod's working space is
unobstructed over the entire stroke range.
Make sure that the piston rod cannot collide with any of the rigid components
in the setup.
KUKA training cell for hands-on education in robotics – Application Kit
CAUTION
WARNING
47