Cleaning And Sterilisation; Preparation - Mectron combi touch Manual De Uso Y Mantenimiento

8

CLEANING AND STERILISATION

This table is purely indicative. For the complete
cleaning and sterilisation procedures of the
individual parts, refer to the paragraphs
indicated in the table.
CAUTION: Methods not considered in the
table below must not be used.
Machine Core Unit, Pedal, Quick Coupling and Relative Cord of Polisher Handpiece and
Phase Chapter
I 8.1

Preparation

II 8.2 Manual cleaning with enzymatic detergent
Phase Chapter
III 8.3 Manual cleaning with enzymatic detergent and running water
Accessories (Scaler Handpiece, Scaler Nose Cone, Inserts, Air-polishing Handpieces, K9
Phase Chapter Procedure
Manual
8.4.1
cleaning
IV
Automatic
8.4.2
cleaning
Check
V 8.5
cleaning
Drying and
VI 8.6
lubrication
Sterilisa-
VII 8.7
tion
NOTE: Repeated reconditioning has a
minimal effect on the devices and their
accessories. The end of the service life of
the accessories is generally determined by
wear or damage resulting from use. Mectron
guarantees the integrity of its sterilisable air-
polishing nozzles and scaler handpieces for
up to 250 reconditioning cycles.
CLEANING AND STERILISATION
WARNING: The sterile single-use
SUBGINGIVAL PERIO TIPs must be used for
one treatment and one patient only. The
single-use SUBGINGIVAL PERIO TIPs must not
be reused. Sort and dispose of each single-
use SUBGINGIVAL PERIO TIP in accordance
with current hospital waste disposal laws.
Scaler Handpiece
Procedure
Tank and Cap
Procedure
Torque, Torque Wrench)
Scaler Scaler
Hand- Nose
piece Cone
Manual cleaning with
Enzymatic Detergent
Thermal-disinfector with detergent
Visual inspection with Lens 2.5x
Drying
Packaging, Sterilisation and Storage
Air-pol-
In- ishing K9
serts hand- Wrench
pieces
Immersion into enzymatic detergent
Ultrasonic Cleaning
Torque
wrench
Drying
and Lu-
brica-
tion
49