Air-Polishing Handpieces - Mectron combi touch Manual De Uso Y Mantenimiento

combi touch
Remove the torque wrench from the
ultrasonic tank and rinse it under running
water so as to eliminate all detergent
residue.
Brush the internal and external surfaces
of the wrench with a clean brush with soft
nylon bristles, under running water.
Process validated by independent bodies with enzymatic detergent.
8.4.1.5 Air-polishing handpieces
Free the channel of the air-polishing
handpiece of any powder residue using
the supplied Ø 0.4 mm cleaning needle,
from both sides.
Blow compressed air into the central hole
of the handpiece, from both ends;
CAUTION: Clean the channel of the
nozzle using only the Ø 0.4 mm cleaning
needle supplied with the appliance.
CAUTION: If the single-use
SUBGINGIVAL PERIO TIP is on the
air-polishing handpiece, remove and
dispose of it.
Place the air-polishing handpiece in a
clean container, in a horizontal position,
and add enough enzymatic detergent
solution to completely
handpiece;
86
26
27
28
cover the