Descargar Imprimir esta página

Blackmagic Design ATEM 1 M/E Manual De Instalación Y Funcionamiento página 34

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 547
Using ATEM Software Control
34
Downstream Key
Fade to Black
Processing Palettes
Downstream Keyers
TIE
The TIE button will enable the DSK on the preview output, along with the next transition effects, and tie it to
the main transition control so that the DSK can be taken to air with the next transition.
The DSK will transition at the rate specified in the RATE display of the transition control block. If the DSK is
tied, the signal routing to the clean feed 1 is unaffected.
ON AIR
The ON AIR button is used to cut the DSK on or off air and indicates whether the DSK is currently on or off
air. The button is illuminated if the DSK is currently on air.
AUTO
The AUTO button will mix the DSK on or off air at the rate specified in the DSK RATE window. This is similar
to the main AUTO rate on the transition control block, however it's limited only to the specific downstream
keyer. This can be used to fade up and down bugs and logos, such as live or replay bugs during production,
without interfering with the main program production transitions.
Fade to Black (FTB)
The FTB button will fade the whole program video output to black at the rate specified in the fade to black
RATE window. Once the program output has been faded to black, the FTB button will flash red until it is
pressed again. Doing so will fade up from black at the same rate, or you can enter a new rate in the Fade
to Black palette in the Switcher tab. Fade to black is mostly used at the start of your production, and at the
end of your production, or when cutting to commercial breaks. It ensures all layers in the switcher are faded
down together. A fade to black cannot be previewed.
Processing Palettes
The following processing palettes are available in the software control panel for the ATEM 1 M/E Production
Switcher model. These change based on the model you're connected to, and are an easy way to see what
processing is available in the switcher. Different ATEM models will have different features, so the palettes
can change. The palettes also show the order of the processing in the switcher.
You can expand and minimize palettes to save space and scroll them up and down to get the adjustments
you need to set.
Color Generator 1 and 2
The ATEM switcher has two color matte generators which can be configured from the color generator
palette using a color picker or by setting hue, saturation, and luminance levels.

Publicidad

loading

Este manual también es adecuado para:

Atem 2 m/e