Publicidad
Idiomas disponibles
Idiomas disponibles
Operating your ATEM Switcher
79
To perform a stinger transition on the broadcast panel
Step 1. From the system control menu buttons, navigate to the media player menu by selecting MEDIA
PLAYER from the home menu and select the media player you plan to use for the transition.
Step 2. Select the CLIPS button and then use the first knob to select between clip 1 and clip 2.
Step 3. Select stinger as the transition type by pressing the STNG button on the ATEM 2 M/E
Broadcast Panel. On the ATEM 1 M/E Broadcast Panel, pressing the DIP/MIX and DVE/
WIPE buttons simultaneously illuminates Both buttons green indicating that the stinger
transition type is selected.
Step 4. From the system control menu buttons, select the media player you chose in step 1.
You can also navigate to the stinger menu by selecting TRANS > STINGER from the HOME
menu.
Step 5. Adjust the preroll, trigger, mix and duration times as needed.
Step 6. Set the logo rate and any other key parameters if required.
Step 7. Perform the transition as an auto transition from the transition control block.
You cannot perform a manual stinger transition using the fader bar.
Broadcast panel stinger transition parameters
preroll
Preroll is a trim in that can be used to trim the beginning of the clip.
The maximum preroll time is 3:00 seconds.
trigger
Trigger is the time at which the switcher will start the background mix transition,
which will occur under the animation. Usually, this is the point when the animation
is full screen.
mix
Mix specifies the duration of the mix that will occur between preview and
program under the animation. To specify a cut instead of a mix simply set the
rate to 1 frame.
duration
Duration refers to the length of the animation. The duration should normally
match the length of the animation. It can also be used to trim out the end of
the clip.
It is important to understand that the trigger, mix and duration times are dependant on one another.
For example the trigger + mix rate cannot be larger than the overall duration. Note also that the time
displayed in the transition rate window is equal to the overall duration + preroll.
Publicidad
