Publicidad
Idiomas disponibles
Idiomas disponibles
MASK
MENU
Using the ATEM 1 M/E Broadcast Panel
48
KEY
KEY
KEY
KEY
1
2
3
4
1
2
3
4
5
6
LUMA
CHROMA
PATTRN
DVE
KEY
KEY
KEY
7
8
9
MASK
MENU
HOME
CAM
0
CLR
Control Panel
Main
ON
ON
ON
ON
Backup
Switcher
CUT
Main
BKGD
KEY 1
KEY 2
KEY 3
KEY 4
DSK 1
DSK 2
FILL
TIE
TIE
Backup
DIP
MIX
SHIFT
DSK 1
DSK 2
CUT
CUT
PREV
CUT
AUTO
DSK 1
DSK 2
FTB
TRANS
AUTO
AUTO
ATEM Mix Effects
HOME
CAM
ON
ON
ON
ON
CUT
BKGD
KEY 1
KEY 2
KEY 3
KEY 4
FILL
DIP
MIX
Preview Bus
SHIFT
The preview bus is used to select a source on the preview output. This source is sent to program when the
next transition occurs. The selected source is indicated by a button that is illuminated green. A blinking
PREV
CUT
AUTO
TRANS
green button indicates that the shifted source is on preview. Pressing the SHIFT button will display the
shifted source.
SHIFT
The SHIFT button provides a global shift and is used to shift the program, preview, and select busses along
with the label. It also provides a shift for the transition type and joystick and other menu functions.
Double-pressing buttons in the preview and select busses, as well as the transition type buttons, is the same
as shift-selecting them and can be a faster way to shift-select buttons. Double-pressing is not implemented
for the program bus as it would cause the program output to momentarily show the wrong source.
Destination Display and Select Bus
The destination display works in conjunction with the source names display and select bus and is used to
assign sources to auxiliary outputs and keyers.
The 8 character destination display and select bus together show you the routing of sources to keys and
auxiliary outputs. The currently selected source is indicated by an illuminated button. A blinking button
indicates a shifted source. A green illuminated button identifies a protected source. Protected sources are
program, preview, clean feed 1 and clean feed 2.
CUT/FILL
When a key setup menu is selected and the CUT/FILL button is pressed, the destination display and select
bus change to show the currently selected cut signal (also known as the Key signal) for that key. When
selecting sources for auxiliary outputs, pressing the CUT/FILL button along with the SHIFT button displays
program, preview, clean feed 1 and clean feed 2 as sources for selection on the select bus.
0
CLR
Control Panel
Main
Backup
Switcher
Main
DSK 1
DSK 2
TIE
TIE
Backup
DSK 1
DSK 2
CUT
CUT
DSK 1
DSK 2
FTB
AUTO
AUTO
Publicidad
