Publicidad
Idiomas disponibles
Idiomas disponibles
Operating your ATEM Switcher
89
Pattern Key Settings
Performing an Upstream Pattern Key
To set up a pattern key on upstream keyer 1 on the software control panel:
Step 1. Expand the upstream key 1 M/E 1 palette and select pattern from the key types bar.
Step 2. Select the fill source.
Step 3. Select the key pattern.
Step 4. Adjust the key parameters to refine the key. For a description of pattern key parameters, refer to
the table below.
To set up a pattern key on upstream keyer 1 on the broadcast panel:
Step 1. Press the KEY 1 button to enable the keyer on the preview output. The system control will
dynamically navigate to the KEY 1 menu. You can manually navigate to the KEY 1 menu by
pressing HOME > EFFECTS KEYS > KEY 1.
Step 2. Select the PATTRN KEY menu button.
Step 3. The destination display will say key1fill on the ATEM 1 M/E Broadcast Panel. On the ATEM 2 M/E
Broadcast Panel, the KEY 1/CUT button will be lit. Select the fill source on the select bus.
Step 4. Select the PATTRN MENU button and use the menu buttons to select a pattern.
Step 5. Adjust the pattern key controls to refine the key.
Pattern key parameters:
Size
Increases and decreases the size of the selected pattern.
Symmetry
Some patterns may have their symmetry or aspect ratio adjusted. Circle patterns
may be adjusted to become horizontal or vertical ellipses. Twist the joystick knob
to adjust its symmetry.
Soft
Changes the softness of the edge of the key signal.
This button is inverts which the region filled with the fill source. For example, fill
Inverse
a region outside of a circle by positioning the circle wipe as desired and then
selecting inverse.
Fly Key
Enables/disables DVE effects
Publicidad
