Publicidad
Idiomas disponibles
Idiomas disponibles
Operating your ATEM Switcher
72
DVE Transition Settings
To perform a DVE transition on the software control panel
Step 1. On the preview bus, select the video source that you want on the program output.
Step 2. Select the DVE transition style in the transition control block.
Step 3. Expand the transition palette and select DVE from the transition types bar.
If the DVE is being used in an upstream key, the DVE transition style button will be unavailable
for selection until the key is taken off air and off next transition. Refer to sharing DVE resources
below for more information.
Step 4. Use the settings in the DVE palette to customise the transition.
Step 5. Perform the transition as an auto transition or manual transition from the transition control
block.
To perform a DVE transition on the broadcast panel
Step 1. On the preview bus, select the video source that you want on the program output.
Step 2. On the ATEM 2 M/E Broadcast Panel, press the DVE button which illuminates yellow. On the
ATEM 1 M/E Broadcast Panel, press the SHIFT and WIPE/DVE buttons to select the DVE transition
type. The WIPE/DVE button illuminates green to indicate the DVE transition type is selected. The
system control automatically navigates to the DVE pattern menu. To manually navigate to the DVE
pattern menu press HOME > TRANS > DVE PATTRN.
If the DVE is already being used in an upstream key, the message DVE unavailable will be
displayed and the DVE transition type will not be available for selection until the key is taken
off air and off next transition. Refer to sharing DVE resources below for more information.
Step 3. Use the system control menu buttons to select the DVE effects, graphic effects and to enable/
disable the DVE Key.
Step 4. Use the knobs and buttons in the system control to customize the DVE transition.
You can also enter a DVE rate using the number pad followed by the set rate button.
Step 5. If you are performing a graphic DVE/WIPE, use the select bus to select the logo fill source. Then
press the DEST SHIFT or CUT/FILL button, depending upon your model of broadcast panel, and
use the select bus to select the logo cut source.
Step 6. Perform the transition as an auto transition or manual transition from the transition control block.
Publicidad
