EMAK BCH 500 Manual De Uso Y Mantenimiento página 55

The following maintenance intervals apply to normal conditions of use only. If daily use is longer than
normal or in the presence of adverse cutting conditions, the recommended intervals should be shortened
appropriately
Whole machine
Controls (STOP button, starter lever, accelerator lever,
safety lever)
Fuel tank
Fuel filter and pipes
Cutting accessories
Bevel gear
Cutting equipment guard
All accessible screws and nuts (with the exception of
the adjusting screws)
Air filter
Cylinder tabs
Start casing slots
Start cable
Carburettor
Spark plug
Vibration dampers
Nuts and screws of the cutting device
MAINTENANCE TABLE
Inspect (leaks, cracks and wear)
Clean at the end of the working day
Check that they operate correctly
Inspect (leaks, cracks and wear)
Clean
Inspect
Clean, replace the filtering element
Inspect (damage, degree of sharpness and
wear)
Check tension
Sharpen
Inspect (damage, wear and level of grease)
Inspect (damage and wear)
Replace
Inspect
Re-tighten
Clean
Replace
Clean
Clean at the end of the working day
Inspect (damage and wear)
Replace
Check the idle (the cutting device must not
rotate with the engine running at idle)
Check the distance between the electrodes
Replace
Inspect (damage and wear)
Replacement by the dealer
Check that the nut of the cutting attachment is
sufficiently tightened
x
x
x
x
x
x
x
x x
x x
x
x x
x
x
x x
x
x
x
x
x
x
x
x
x x
x
EN
x
x
x
x
49