Publicidad
Idiomas disponibles
Idiomas disponibles
4.8.
Further risks
The proper design of the equipment and the
installation
of
adequate
completely exclude risks to the operator.
This
manual
lists
the
equipment to be used by the operator.
Sufficient space is provided during the installation
of the equipment to limit the risks. To maintain
these conditions, the areas surrounding the
equipment must be kept clean, dry, well lit and
free of obstacles.
The following is a list of possible risks that may
still occur.
Possible
risks
The operator may slip due to
Slip or fall
water, oil or dirt on the floor.
The
user
unintentionally
Burns
components inside the appliance
Abrasion
(e.g. cold pans, cooling fins and
cooling
wearing protective gloves.
5.
TRANSPORT AND STORAGE
5.1.
General Information
The equipment must be transported and handled
using appropriate means with adequate capacity.
!
During transport and
handling
of
the
equipment, it is strictly
forbidden to stack one
machine on top of the
other, in order to exclude
the risk of loads tipping
over due to stacking.
The
equipment
must only be transported,
5.2.
Transport and Handling
!
It is forbidden to stand under suspended
loads during handling and transport. Unauthorised
personnel may not enter the work area. The
transported
load
can
accelerating, cornering and on rough roads.
protection
do
not
personal
protective
Description
intentionally
or
touches
certain
circuit
tubes)
without
move
when
braking,
Possible risks
Contact with live electrical parts
during maintenance operations
Electrocution
performed without disconnecting
the power supply.
The operator intervenes on the
Fall
equipment
means to access the upper part.
The upper control panel may not
Injuries
be secured properly by qualified
personnel. It may close abruptly.
During equipment and packaging
handling
Tipping
unsuitable lifting and/or handling
equipment or with an unbalanced
load
Inhalation of cooling gas. The
type of refrigerant can be found
Cooling gas
on the equipment's identification
plate.
handled and stored by skilled staff.
Minimum requirements for skilled staff are as
follows:
•
specific technical training and experience in
the use of lifting systems;
•
knowledge
of
applicable laws;
•
knowledge of general safety requirements;
•
respect for the use of personal protective
equipment in accordance with the operation
performed;
•
the ability to identify in advance and avoid
any possible danger.
!
The equipment must be handled in a vertical
position. It is forbidden to move the equipment in
a horizontal position. If the equipment is handled
in a horizontal position, wait a few hours before
operating it.
For the correct performance of lifting operations,
use the most suitable type of equipment in terms
9
ENGLISH
Description
using
unsuitable
operations
using
safety
regulations
and
GB
Publicidad
