Publicidad
Idiomas disponibles
Idiomas disponibles
HACCP alarms display
Make sure the keyboard is not locked.
Keep the
screen will display the letters "rtc". Press the
key repeatedly until the letters "LS" appear. Press
the
key: the screen will display the code for
the most recent alarm (in other words, one of the
codes listed above followed by number "1"; the
greater the number that follows the code for the
GB
alarm, the older it is). With the
it is possible to scan the various stored alarms.
To select an alarm press the
led will stop flashing and stay on steadily, the
screen will display the following information in
sequence:
8.0
the critical value is 8.0 °C/8 °F
StA
the screen is about to display the
date and time when the alarm
was set off
y09
the alarm was set off in 2009
(continue ...)
n03
the alarm was set off in the month of
March (continue ...)
d26
the alarm was set off on March 26,
2009
Cancelling the list of HACCP alarms
Make sure the keyboard is not locked.
Keep the
screen will display the letters "rtc".
Press the
"rLS" appear.
Press the
requested in order to cancel the alarms from the
memory.
Compressor operating hours
The appliance can store up to 9,999 compressor-
operating hours, after which the number "9999"
flashes.
To display the compressor operating hours follow
the instructions below.
Make sure the keyboard is not locked.
Keep the
screen will display the letters "rtc".
Press the
"CH" appear.
Press the
ENGLISH
key pressed for 1 second: the
and
key: the
key pressed for 1 second: the
key repeatedly until the letters
key: the password will be
key pressed for 1 second: the
key repeatedly until the letters
key to view the data.
h16
the alarm was set off at16:00
(continue ...)
n30
the alarm was set off at16:30
(continue ...)
dur
the screen will display the duration of
the alarm
h01
the alarm lasted for 1 h (continue ...)
n15
the alarm lasted for 1 h and 15 min
AH3
the selected alarm
The screen displays every piece of information for
1 second.
keys
To exit the sequence of information: press and
release the
selected alarm ("AH3" in the example).
To exit the procedure, press the
screen will display the temperature read by the
cold room probe again.
If the tool does not have any alarms in its
memory, the "LS" label will not be displayed.
With the
149 : press the
the alarms.
If the tool does not have any alarms in its
memory, the "rLS" label will not be displayed.
To reset the counter to zero follow the instructions
below.
Make sure the keyboard is not locked.
Keep the
screen will display the letters "rtc".
Press the
"rCH" appear.
Press the
order to reset the counter to zero.
20
key, the screen displays the
and
keys enter the password
key to confirm the deletion of
key pressed for 1 second: the
key repeatedly until the letters
key: the password is required in
key: the
Publicidad
