Publicidad
Idiomas disponibles
Idiomas disponibles
7.3.
Functioning
Temperature Blast chilling
1
Select the blast chilling by pressing
and
will blink. The display shows the end
blast chilling temperature value.
By pressing the
temperature value (+3°C) can be changed.
Insert the core probe into the product.
Press
key to start. Led
permanently on.
The test for the proper insertion of the probe will
start.
If the test gives a positive result, the blast chilling
cycle starts, in case of negative result the
machine will run a timed blast chilling (see proper
chapter)
Hard Temperature Blast Chilling cycle
1
Select blast chilling by pressing
and
will blink. To select the hard cycle
press
: LED
blinks.
The
display
show
the
temperature. Using
blast chilling temperature (+3°C) can be changed.
Insert the core probe into the product. Start the
2
key: led
and
keys the
and
will be
3
2
key: LEDs
end
blast
chilling
and
key the end
During blast chilling the display shows the
temperature detected by the core probe. By
pressing the
key, temperature detected by
the chamber probe can be visualized.
If
the
product
established value within the set blast chilling time,
the cycle is considered as completed and a
preserving cycle is automatically started and an
intermittent sound confirm the correct conclusion
of the cycle.
In case the product temperature does not reach
the on parameter r5 established value, the cycle
continues: the led
an intermittent sound. To stop the alarm press a
key.
As soon as product temperature is lower than the
established value the blast chilling cycle is
considered as completed and a preserving cycle
is automatically started.
During preservation the display shows the
temperature detected by the chamber probe; LED
is switched on.
Press
to conclude the preservation cycle.
cycle by pressing the
and
are permanently on.
The test for the proper insertion of the probe will
start.
If the test gives a positive result, the blast chilling
cycle starts, in case of negative result the
machine will run a timed blast chilling (see proper
chapter)
The working set point of the hard phase is
established
on
parameter
temperature
detected
corresponds
to
the
parameter r13, the hard phase is considered as
completed.
During blast chilling the display shows the
temperature detected by the core probe. By
pressing the
key, temperature detected by
the chamber probe can be visualized.
15
ENGLISH
temperature
reaches
will blink accompanied by
key. LED
,
r9.
Once
by
the
core
probe
value
established
the
GB
the
on
Publicidad
