Publicidad
Idiomas disponibles
Idiomas disponibles
Temperature Shock Freezing
Select shock freezing by pressing
,
,
and
shows the end cycle temperature. Using the and
keys the end shock freezing temperature (-18°C)
can be changed. Insert the core probe into the
product. To select the SOFT cycle press the key.
LED
will turn off.
Start the cycle by pressing key
and
are permanently on.
The test for the proper insertion of the probe will
start.
If the test gives a positive result, the blast chilling
cycle starts, in case of negative result the
machine will run a timed blast chilling (see proper
chapter).
Time Shock Freezing
Select the freezing process pressing twice the
button
, the leds
blink. The display shows the time of the cycle.
Using the buttons
and
the time of freezing
To select a soft cycle, press the button
the LED
will turn off.
3
1
2
key: LED
blink. The display
. LED
,
3
1
2
,
,
and
you can change
:
During shock freezing the display shows the
temperature detected by the core probe.
By pressing the
by the chamber probe can be visualized.
If
the
product
established value within the established time set
on parameter r6, the cycle is considered as
completed:
a preserving cycle is automatically
started and an intermittent sound confirm the
correct conclusion of the cycle.
In case the product temperature does not reach
the established value within the maximum time
allowed, the cycle continue:
accompanied by an intermittent sound. To stop
the alarm press any key.
As soon as product temperature is lower than the
established value the shock freezing cycle is
considered as completed and a preserving cycle
is automatically started.
During preservation the display shows the
temperature detected by the chamber probe; LED
is switched on.
Press
to conclude the preservation cycle.
To start the cycle, press the button
leds,
,
and
At the end of the set time, the freezing cycle is
completed and automatically starts a cycle of
conservation.
During the storage phase the display shows the
temperature measured by the room probe, the
LED
is turned on.
Press the button
conservation.
17
ENGLISH
key, temperature detected
temperature
reaches
LED
blinks
:. The
remain lit steadily.
to end the cycle of
the
GB
Publicidad
