Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
CARRIAGE INSTALLATION
shipping
brace
extra piece
of gear rack
MAXIMUM 1/8" (3 mm)
Fig. 2
Fig. 4
Fig. 6
© BRUNO INDEPENDENT LIVING AIDS, INC.®
NOTE: Before installing carriage, check
Prepare Rail
1. Turn OFF circuit breaker (Fig. 9).
2. Remove upper charge contact from rail.
3. Remove top two (2) gear rack segments
Fig. 1
4. Before installing carriage, use a 4mm
5. Make sure distance between folding rail
6. Raise short rail to provide access to latch
7. Insert latch, aligning holes (Fig. 4).
Fig. 3
8. Hold latch in position while inserting
9. Using 4 mm Allen wrench, tighten two
Fig. 5
10. Lower short rail to ground (Fig. 7).
11. Install carriage on rail.
Fig. 7
front shroud
Fig. 8
18
angle of stairs. If less than 25°,
it is easier to adjust carriage with
it off the rail. See chart on page 41.
to facilitate sliding carriage on rail.
hex key to remove two (2) button head
screws from shipping brace on folding
rail and extra piece of gear rack (Fig. 1).
and ground is NO MORE THAN 1/8" (3 mm).
The closer to the ground, the better (Fig. 2)!
installation location (Fig. 3).
NOTE: Spacer plate should contact
rail extrusion when installed.
screws (Fig. 5).
NOTE: Failure to hold onto latch will
allow it to slide to end of short rail.
If this occurs, you must remove
short rail end plate to retrieve latch.
screws (Fig. 6).
NOTE: Make sure the screws are
tight and properly seated!
Tip: Remove front shroud (Fig. 8)
to make it easier to transport the
carriage, OR... lift and carry carriage
as shown in Fig. 9. NEVER lift up by
carriage switch housing!
a. Slide carriage onto rail until it meets
gear rack.
b. Cut cable tie securing decal sheet and
key to circuit breaker.
c. Remove serial number decal from sheet
and apply it to seat as instructed on decal
sheet.
SRE-2010 INSTALLATION 02-08-2019
Publicidad
