Bruno SRE-2010 ELITE Manual De Instalación página 46

TROUBLESHOOTING
RESET FOLDING RAIL JOINT
gap
M5 button
head screw
folding rail
jack screw
piece of spare
gear rack
© BRUNO INDEPENDENT LIVING AIDS, INC.®
1. Confirm factory-set gear rack gap (slight
space between main rail and folding rail
gear racks) is at folding joint (Fig. 1).
2. Loosen folding rail jack screw after jack
screw in top endplate has been tightened.
3. Loosen M5 button head screw securing
folding rail rack (Fig. 2).
4. Use a piece of spare gear rack to cover
joint between main rail and folding rail
(Fig. 3). This ensures pitch is maintained
for safe travel of drive gear and overspeed
gear (SRE-2010C/OS only) across joint.
Fig. 1
5. Slowly tighten folding rail jack screw until
loose gear rack piece falls away.
6. Tighten M5 button head screw to secure
top piece of short folding rail.
NOTE: NEVER remove main rail screw
Fig. 2
Fig. 3
46
from rail! Carriage and
gear rack segments will fall.
SRE-2010 INSTALLATION 02-08-2019