Bruno SRE-2010 ELITE Manual De Instalación página 9

LOWER RAIL PREPARATION (continued)
JOINT PREPARATION
NOTE: Lower charge contact is assembled
at factory for folding rails.
joint pin
upper joint
bracket
lower
joint
bracket
Wait to install second screw
until after upper rail is installed.
SRE-2010 INSTALLATION 02-08-2019
9. Use 1/2" socket to install two (2)
Fig. 6
10. Insert slow down strip into lower charge
Fig. 7
1. Pound barbed end of rail joint pin halfway
2. Into upper part of lower rail section,
front of rail
3. Into lower part of lower rail section,
Fig. 1
9
PRE-INSTALLATION
5/16" x 18 self-threading screws
to mount the lower rail endplate
(Fig. 6). A dab of grease will make
installation easier.
NOTE: Threaded hole in endplate goes
toward front side of rail.
NOTE: DO NOT use an impact drill
to install these screws.
contact, keeping it parallel to and touching
top edge of charge strip carrier.
Using two (2) self-drilling
hex head screws, secure slow
down strip to rail (Fig. 7).
NOTE: Make sure slow down strip is
parallel to charge strip carrier,
and touching top edge of carrier.
F 1-
or piece rail installations
U r
skip to pper ail
into lower rail (Fig.1).
insert an upper joint bracket halfway* in.
Secure one (1) of two (2) self-
drilling hex head screws (Fig. 1).
* Both upper and lower joint brackets
are notched to indicate halfway point.
insert a lower joint bracket halfway* in.
Secure one (1) of (2) self-drilling hex head
screws (Fig. 1).
© BRUNO INDEPENDENT LIVING AIDS, INC.®
,
p .
reparation