Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL
REPROGRAMMING REMOTE TRANSMITTERS
dip switch
Fig. 1
control enclosure covers
LEARN/ERASE
button
Fig. 3
© BRUNO INDEPENDENT LIVING AIDS, INC.®
NOTE: Operating channel of two (2)
Reasons for reprogramming transmitters:
• multiple units in same location;
• transmitters need to be replaced.
Reset operating channel of transmitters:
1. Remove transmitter(s) battery access
2. Locate DIP switch (Fig. 1).
3. Change BOTH transmitter DIP switches
Reprogramming transmitters:
Fig. 2
1. Turn circuit breaker OFF.
2. Remove seat hinge plate cover to expose
3. For left-hand unit, remove lower side
4. Turn circuit breaker ON. Wait for "power-
5. Locate LEARN/ERASE button on circuit
6. Clear memory.
34
transmitters included with SRE-2010
is pre-set at the Bruno factory.
panel.
to one (1) of four (4) possible options.
• 1 up, 2 down (default factory setting)
• 1 up, 2 up
• 1 down, 2 up
• 1 down, 2 down
circuit board.
control enclosure cover (Fig. 2);
for right-hand unit, remove upper side
control enclosure cover to view LEARN/
ERASE LED on circuit board.
up" beep.
board (Fig. 3).
• Hold down LEARN/ERASE button until
the LED on circuit board goes out
(approximately 12 seconds).
SRE-2010 INSTALLATION 02-08-2019
Publicidad
