Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
MAKE CHARGER CONNECTIONS - FOLDING RAIL
SRE-2010 FOLDING RAIL CONFIGURATION SHOWN:
RIGHT-HAND INSTALLATION (CHARGER AT TOP)
BATTERY CHARGER OUTPUT CONNECTOR
(ALREADY CONNECTED TO RAIL CHARGE HARNESS)
CHARGER ADAPTOR
RAIL CHARGE HARNESS
SOFT-STOP STRIP
CONTINUOUS CHARGE STRIP
SRE-2010 FOLDING RAIL CONFIGURATION SHOWN:
RIGHT-HAND INSTALLATION (CHARGER AT RAIL JOINT)
GEARBOX ASSEMBLY
RAIL CHARGE HARNESS - (LOWER CHARGE CONNECTION)
CHARGER ADAPTOR
BATTERY CHARGER OUTPUT CONNECTOR
© BRUNO INDEPENDENT LIVING AIDS, INC.®
WIRING AND CONNECTIONS CONTAINED WITHIN RAIL
CHARGE CONTACT HARNESS
RED
RED
BLACK
BLACK
CHARGE CONTACT ASSEMBLY
RED
BLACK
BATTERY CHARGER OUTPUT CABLE
1.
Connect wires from charger to charge contact
assembly. (See figures at left.)
2.
Attach adhesive wire clip to rail and fold tab
over wires as shown below.
26
SRE-2010 INSTALLATION 02-08-2019
Publicidad
