Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS, TORQUE SPECIFICATIONS, AND HARDWARE NOTES
Tools
• Drill driver with MINIMUM 18" extension
• Drill bits: appropriate for floor (eg. concrete, hardwood); 3/8", min. 6" long
• Cut-off saw (or other power saw with metal-cutting blade suitable for aluminum/
steel)
• Metric open-end box wrench set
• Adjustable wrench with 1-1/2" jaw (for changing to opposite hand)
• Torque wrench (open end, and one that handles 50-80 ft.lb./68-108 Nm)
• Ratchet, 3/8" with 6" extension
• 1/2" SAE socket
• Metric sockets (10 mm, 13 mm, 17 mm)
• 10mm magnetic socket, 3/8" drive (Bruno recommends use with an 18" extension)
• Vise grips and C-clamp vise grips
• Needle-nose pliers
• Metric hex key set
• Magnetic Phillips screwdrivers
• Soft-faced or dead-blow hammer,
or hard rubber or rawhide mallet
• Multimeter
• Extension cords
• Saw horses
• Safety glasses
Next:
• Determine if the application requires installation of a manual or power
folding rail.
Use FIX-00525 rail clamp tool
(available from Bruno).
OR Bar/Sping clamp with piece of gear rack
• Follow OEM torque recommentations for seat
Torque
mounting hardware. If not available, refer to
Specs
table on right indicating ISO and SAE
recommended assembly torque specifications.
If it becomes necessary to replace any bolts or
fasteners, use only metric GRADE 10.9 (hardened steel) hardware.
Metric grade 10.9 bolts are identifed by the number 10.9 on the head.
Bolts without grade markings on the head are not strong enough to be safely
used in this application.
SRE-2010 INSTALLATION 02-08-2019
METRIC 10.9
BOLT HEAD
10.9
5
• Torpedo level
• Tin snips
• Utility knife
• Wire stripper
• Wire crimper
• Metal file
• Scratch awl
• 20' tape measure
• Flashlight
• Threadlocker (i.e., Loctite®)
Torque Specifications
GRADE 10.9 (Metric)
(Rough equivalent to US Grade 8)
M 6 ........ 7 lb.-ft ..... 9.49 Nm
M 8 ...... 25 lb.-ft ..... 33.8 Nm
M 10..... 47 lb.-ft ..... 63.7 Nm
© BRUNO INDEPENDENT LIVING AIDS, INC.®
Publicidad
