Publicidad
Idiomas disponibles
Idiomas disponibles
SEAT INSTALLATION
Fig. 2
SRE-2010 INSTALLATION 02-08-2019
carriage harness
footrest harness
Fig. 1
Fig. 3
Fig. 4
27
INSTALLATION
1. Remove and save shipping jumpers from
carriage harnesses.
Connect 2-pin connector from carriage to
footrest harness (Fig. 1).
2. Mount rear seat support bracket.
See Fig. 2 for location.
Use an M-10 bolt and safety lockwasher.
Do not tighten at this time.
3. Mount seat on carriage.
Tilt seat forward slightly, and set into
notches of adjustable seat bracket (Fig. 3).
4. Connect remaining two (2) wiring harnesses:
• 6-pin: seat swivel to rocker switch
• 12-pin: seat swivel to diagnostic board
5. Loosely secure seat.
Insert two (2) hex head bolts and washers
through front seat bracket holes (Fig. 4).
© BRUNO INDEPENDENT LIVING AIDS, INC.®
Publicidad
