Bruno SRE-2010 ELITE Manual De Instalación página 42

POST-INSTALLATION ADJUSTMENTS
ARMREST EXTENSION ADJUSTMENT
© BRUNO INDEPENDENT LIVING AIDS, INC.®
1. Remove arm swivel cover (Fig. 1).
2. Cut cable tie (Fig. 2).
3. Remove three (3) arm bracket screws (Fig. 3).
Fig. 1
4. S lide arm out to position that best fits user
5. Insert and tighten three (3) arm bracket
Fig. 2 6. Wind wire into a service loop (no cable tie
7. Remount arm swivel cover and secure with
Fig. 3
8. Repeat these steps for opposite side (units
Fig. 4
Fig. 5
42
(Fig. 4).
NOTE: There are three (3) possible settings.
screws.
needed).
its screw.
• Do not overtighten!
• Make sure wire sits in cover slot (Fig. 5).
without a keyswitch).
SRE-2010 INSTALLATION 02-08-2019