Tunturi E90L Manual Del Usuario página 3

REAR AND FRONT SUPPORT
H-7
J-R
By holding on to the seat, incline the equipment
backwards so that it rests on its transportation wheels.
Attach the rear support from below with four hexagonal
socket head screws and washers. Attach the front
support to the frame with four screws and washers.
Restore the equipment to its upward position so that it
rests on the support feet.
PEDALS
The pedals are distinguished by the markings R (= right)
and L (= left) on their shafts. Fasten the right pedal to
the right pedal crank turning clockwise and the left
pedal to the left pedal crank turning counterclockwise.
Fasten the pedal bands first into the retainerat the
device. Thread the band through the pedal loop and
push the band opening into the projection in the pedal.
Fasten the pedal bands to the pedal outside. Push the
band through the locking buckle and the band locks
automatically. The length of the band can be adjusted
with the locking buckle.
CONSOLE
A
A-2
B-3
Connect the cables from the handlebar to the
corresponding connectors of the console. Insert the
connected cables into the console, but make sure they
are not damaged when the console is attached. Place
the meter in position at the end of the handlebar support
tube and attach the console using 4 mounting screws.
SEAT
J-L
K-2
K-6
Loosen the seatholder locking screw and turn the upper
N-1
locking lever so that it is aligned with the equipment.
H-4 N-2
Place the seat into position on the grooves of the lower
locking lever. Turn the upper locking lever towards the
top of the seat rails and lock the seat by tightening the
locking screw.
POWER CORD
Plug the socket end of the transformer cord into the
connector, just above the rear support in the centre of
the frame, and the other end into the wall socket. To
prevent damage to the connector, we recommend you
tie the cord to the transportation wheel support next to
the connector.
ADJUSTMENTS
Set the right height for you; the basic rule is that the
arch of the foot reaches reaches the the pedal at its
lowest point with the leg almost straight. Adjust the
seat height by loosening the seat locking knob. Hold on
to the seat with one hand and, using your other hand,
pull the locking knob outwards in order to enable free
seat tube movement upwards and downwards. Once the
height is right, let go of the knob and the seat locks into
place. Turn the locking knob clockwise to tighten.
properly fastened before starting to exercise!
C-2
To adjust the horizontal seat position forward and back,
loosen the locking screws under the seat. You can also
adjust inclination from here. Release the seat lock by
A-1
turning the locking lever located under the seat
anticlockwise. Adjust the seat to the desired position and
tighten the locking lever by turning it clockwise.
HANDLEBAR SETUP
Loosen the locking screw on the front of the handlebar
support and find the right angle at which to position
the handlebar. Tighten the locking screw. The design of
the handlebar allows you to exercise either in an upright
position or with the upper body leaning forward.
Remember, however, always to keep your back straight.
CONSOLE INCLINATION ADJUSTMENT
Set the inclination of the meter so that it
corresponds to your height and exercise position.
ADJUSTMENT OF SUPPORT FEET
If the equipment is not stable, adjust the adjustment
screws below the support feet as necessary.
3 3
K-1
NOTE! Always make sure that the locking knob is
E90L - OWNER'S MANUAL ENGLISH