Publicidad
Idiomas disponibles
Idiomas disponibles
Aesculap
Xenon Light Source OP930
Opening the device
►
Rotate the fast-action locks 17 90° in a counterclockwise direction.
►
Pull the cover slightly outwards and raise it.
►
Make certain that the ground cable is not under any strain by being
pulled on.
Removing xenon lamp
E
D
Fig. 1
Legend
A Wire loop
B Plug tabs
C Lamp connector
D Ceramic socket
E
Lamp body
►
Loosen lamp connector C:
– Squeeze the laterally mounted plug tabs B together.
– Withdraw lamp connector C at the same time.
►
Release the wire loop A on either side and fold them back.
►
Grasp the xenon lamp by its ceramic socket D and push it backwards.
At the same time incline the xenon lamp slightly downwards and open
the two fastening brackets.
10
®
A
B
B
C
Installing xenon lamp
C
F
Fig. 2
Legend
A Bushing
B Bushing flange
C Groove
D Lamp connector
E
Ceramic socket
F
Positioning flange
►
Grasp the xenon lamp by its ceramic socket E.
►
Incline the xenon lamp and its underside forwards.
►
Insert the positioning flange F of the xenon lamp in the groove C of the
lamp holder and push it forward. Make certain that the lower edge of
the reflector touches the lamp holder.
►
Push the xenon lamp forward until the upper segment of the edge of
the reflector touches the xenon lamp holder and the lamp snaps into
the two fastening brackets.
►
Suspend the wire loop.
The xenon lamp is now fixed in place.
►
Plug lamp plug D into bushing A. Ensure that the plug tabs snap into
place in the bushing flange B.
►
Setting back the operating time counter, see Setting back the operat-
ing time counter
B
A
D
E
Publicidad
