Publicidad
SC Series Controllers
For your safety
2.2
Safety instructions for SC series controllers
To Avoid Injury:
1. Save these instructions for future reference.
2. Read and understand all the safety recommendations and all operating instructions before operating tools
and controllers. Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
3. Train all operators in the safe and proper use of power tools. Operators should report any unsafe condition
to their supervisor.
4. Follow all safety recommendations in the manual that apply to the controllers, tools, battery packs and
chargers being used, and the nature of the work being performed.
5. Verify that all warning labels illustrated in this manual are readable. Replacement labels are available from
STANLEY Assembly Technologies.
6. Only allow suitably qualified personnel to install, program, or maintain this equipment and or system. Follow
all manufacturer installation instructions and applicable regulatory electrical codes and safety codes.
7. These persons must be knowledgeable of any potential sources of danger and maintenance measures as
set out in the Installation, Operations, and Maintenance manual.
8. This product must be transported, stored, and installed as intended, and maintained and operated with care
to ensure that the product functions correctly and safely.
9. Persons responsible for system planning and design must be familiar with the safety concepts of automation
equipment.
10. Install tools in dry, indoor, non-flammable, and non-explosive environments only–Humidity: 0 to 95%
noncondensing and Temperature: 32 to 122 ºF (0 to + 50 ºC).
11. Do not install worn, damaged, or modified equipment that may be unsuitable for safe use.
12. Controller plugs must match the outlet and must be earth grounded. Never modify a plug in any way or use
any adaptor plugs.
13. Avoid body contact with electrically energized surfaces when holding a grounded tool.
14. Prior to connecting a power source, always ensure the tool or controller is turned off.
15. Limit controller access to trained and qualified personnel.
16. Store idle tools and accessories in a safe location accessible only by trained persons.
17. Disconnect power source (battery, electricity, etc.) from tool or controller prior to making adjustments,
changing accessories, or storing.
18. Prior to operation, always check and test tools and accessories for damage, misalignment, binding or any
other condition that may affect operation. Maintenance and repair should be performed by qualified
personnel.
19. Do not operate tools in or near explosive environments or in the presence of flammable liquids, gases, dust,
rain or other wet conditions.
20. Keep the work area clean, well-lit and uncluttered.
21. Keep unauthorized personnel out of the work area.
2.3
Safety warning on the product
The following safety warnings must always be legible and attached to the product undamaged.
12 / 1032
Read and understand all
the safety
recommendations and all
Indicates a pinch point
hazard. This icon appears
as a part of a DANGER,
WARNING, or CAUTION
notice.
Publicidad
