Publicidad
8.2.2.2
Update interactive menu button
Under Service Card Header -> select Controller Card ->Select Update Button
This button is used to update the firmware in the SC controller.
Download a software BIN file from the Internet and transfer it to a USB memory stick. Insert the USB memory
stick into the USB port on the bottom of the SC controller. Scroll to the binary file provided and then press the
OK interactive menu button.
A progress bar on the top of the screen indicates the file transfer status from the USB memory stick to the SC
controller memory.
When the file transfer is complete, the "Cycle Ok" window appears indicating it is time to reboot the controller to
complete the upgrade. Turn off the controller, remove the USB memory stick, wait 20 seconds, then turn on the
controller.
After the controller starts, it checks that the file is complete and written to permanent memory. The controller
auto-reboots. When the run screen appears, the controller is updated and ready.
During the file transfer process, a file error can cause the transfer to abort and the error message appears.
Contact your STANLEY representative if this happens.
The "Invalid File" screen appears if the update file is for a different controller. Contact your STANLEY
representative if this happens.
Trailing controllers and QPM Cordless Tools that are connected to the SC Controller may also be updated this
way by simply choosing the spindle before selecting SERVICE -> CONTROLLER. It is advised to update trailing
controllers and B-Series QPM Cordless Tools before updating the lead controller.
8.3
Analyze area
Analyze displays tool and controller diagnostic information, Traces, Rundowns, Logs, Statistics and I/O status.
Press the Analyze button menu to perform diagnostics on the controller, tool or I/O, look at fastening cycle
traces, perform statistical process control analysis, or to download error log data.
8.3.1
Rundowns
Under Analyze card header -> Select Rundowns card
The SC controllers stores resultant audit data for 30,000 fastening cycles on a first in/ first out basis. Click on
the rundown that corresponds to the trace to be retrieved.
8.3.1.1
Rundowns menu
Under Analyze card header -> Select Rundowns Card
Rundowns contains all the generated fastening cycle data and traces.
Details: Rundowns contains the fastening cycle details. On a SC controller, under Analyse select Rundowns
and click on "Details" button details dialog box will appear.
SC Series Controllers
Configuration
93 / 1032
Publicidad
