Publicidad
7 Tool connector
9 24 DC I/O connector
11 Spindle Disconnect
NOTE
Ports/Connectors availability depends on model purchased.
5.3
SC controller connections
Each SC controller has a different combination of connectors. These connectors serve several purposes, such
as:
● Power
● Tool Connections
● Discrete inputs and outputs
● Communications ports
● Fieldbus ports
5.3.1
Power cord
SC controllers use an IEC 60320 style connector. The wall plug is based on customer requirements. The power
cord should be rated at either 15A/125V for 115V AC or 10A/250V for 230V AC power connections.
5.3.2
Tool connector
SC controllers use a single 30 pin connector to connect one QPM EB DC electric tool cable. QPM EB DC
electric tool cables use a MIL-Spec connector clocked in the B position.
5.3.3
USB connector
The USB connector is used for data transfer between a USB memory stick and the controller, controller
upgrades and for receiving PART ID ASCII data from a USB barcode scanner. No mounting or unmounting of
the memory stick is required. Simply insert a USB memory stick when requested and remove after the operation
is complete.
8 Power input
10 Serial port connector
12 Fieldbus Connectors
30-pin tool connector
SC Series Controllers
Product overview
21 / 1032
Publicidad
