Publicidad
SC Series Controllers
Configuration
Pre-Torque:
The pre-torque runs the fastener to a preliminary torque level and suspends the fastening cycle for a period of
time. After a time delay, the Audit step begins. Creates a Smart Step with a Torque Control/Angle Monitoring
strategy in the same direction as the Audit step is programmed. If selected, this is the first step AFTER Self Tap.
Torque Recovery:
Creates the Strategy used for Torque recovery (relaxation in a joint) after the Audit step. The wizard makes the
Torque Recovery step the Audit Step. The Torque Recovery step will inherit the High, Low, and Target torque
values set during the Audit step setup. Sets Merge Torque to Yes. Sets Accumulate Angle to Yes. Sets Torque
Display to Final for both steps.
Backout:
Accommodates assembly procedures requiring partial removal of the fastener before additional components
can be added to the joint. Creates a Back off strategy Smart Step after the Audit step. The tool stops after
achieving either the angle or torque target. If selected, this is the first step AFTER the Audit step.
Release:
In some fastening situations sockets become stuck on the fasteners. This step reverses the tool and releases
the socket without loosening the fastener. Creates the strategy Smart Step that rotates the fastener in the
opposite direction of the Audit step.
8.1.1.2.2.1
Step menu
Add
Delete
Copy
Paste
8.1.1.2.3
Set
Under Setup card header -> Select Jobs card -> Select Job card header -> Select Task card header -> Set
Below are the list of Blind Rivet Tool parameters
50 / 1032
Adds a Step to the selected Task.
Select the Add and select the strategy function from the dropdown list then
click ok. Choose before or after for inserting new step. Select the step and
finally click ok.
STRATEGY creates a step using a strategy from the list above. Only
Strategy steps can be assigned as audit steps.
WOBBLE, SLOW SEEK, SELF TAP, PRE-TORQUE, BACKOUT and
RELEASE selections create
Smart Steps in their required order. Smart Steps cannot be audit steps. See
section "Wizard Screens" for a description of these Smart Steps.
Deletes the selected Step from the Task. Steps cannot be recovered once
deleted.
Copies the selected Step to the Clipboard.
Overwrites the selected Step with the values residing in the Clipboard.
To copy/ move a Step: first create a new Step where it is needed, than copy
the Step to be moved, then paste into the new Step created and delete the
original if required.
Publicidad
